Duminy Designs

ISO Fits & Tolerances Calculator

Hole and shaft limits, deviations and the clearance or interference of any ISO 286 fit, such as H7/g6, H7/k6 or H7/p6, for sizes up to 3150 mm. Type a callout straight off the drawing. Free, metric, no login.

For example 25 H7/g6, Ø40 h6 or 12 P7.

Show
Hole
Shaft
Preferred fits
Check a measured part

Limits from the ISO 286-1 and ISO 286-2 tables of standard tolerances and fundamental deviations. Check critical work against the standard and the drawing.

Preferred fits at Ø25

The ten ISO preferred fits, loosest to tightest, worked out for the size you entered. Click a fit to open it in the calculator.

How it's worked out

A fit callout such as 25 H7/g6 gives the nominal size, the hole class (capital letter) and the shaft class (small letter). The letter places the tolerance zone; the number sets its width.

IT grade
The number (01, 0, 1 to 18) is the standard tolerance grade. Its width in µm comes from the ISO 286-1 table for the size range the nominal size falls in, for example IT7 = 21 µm over 18 up to 30 mm.
Letter
The fundamental deviation: the limit nearest the zero line. H and h sit on it, a to g (A to G) give clearance, j to n are transition, p to zc (P to ZC) give interference.
es, ei / ES, EI
Upper and lower deviation of the shaft / hole. The other limit is the fundamental deviation plus or minus the IT value.
Δ
Holes K, M and N up to IT8 and P to ZC up to IT7 get the Δ correction from the standard, so that H7/p6 and P7/h6 give the same fit.
js, JS
Symmetric about the zero line, ±IT/2.
Max clearance
Largest hole minus smallest shaft (ES − ei).
Min clearance
Smallest hole minus largest shaft (EI − es). A negative clearance is interference.
Fit type
Clearance if the minimum clearance is zero or more, interference if the maximum clearance is zero or less, transition when it can be either.
GO / NO-GO
Plug or ring gauge sizes: GO is the maximum material size (smallest hole, largest shaft), NO-GO the least material size.
Size range
Over 0 up to 3150 mm. a, b, c, cd, ef, fg, j, v to zc and their capitals are only tabulated up to 500 mm or less, as in the standard.

Machining it on a lathe or mill?

The free Feeds & Speeds Calculator gives spindle rpm and feed rate for the cut. The full CNC tools, from a lathe program builder to setup sheets made from the G-code, sit behind a client login.

See the CNC tools