Duminy Designs

Bolt Circle PCD Calculator

Find the pitch circle diameter (PCD) of a hole pattern with no drawing: measure across two holes with a caliper, enter the hole count and read off the PCD, with the nominal size it most likely was. Free, no login.

Know the PCD already and need the hole positions? Use the Metric Bolt Circle Layout.

Units
What you measured
Equally spaced on a full circle.
Sets the band used to pick the likely nominal PCD.
Decimals

Likely nominal PCD

Lay out these holes

Measure two or three pairs of holes and use the average. A single worn or badly drilled hole moves the answer.

How to measure it

A chord is a straight line between two points on a circle. The centre distance between two holes is a chord of the pitch circle, and with the hole count it fixes the PCD.

Caliper trick: measure the hole Ø, press zero on the caliper, then measure over the outside edges of the two holes. The display now reads the centre distance directly (outside over the holes minus hole Ø).

Centres
Centre-to-centre distance between the two holes. This is the chord.
Outside edges
Outside jaws over the far edges of both holes. Chord = reading − hole Ø.
Inside edges
Inside jaws between the near edges of both holes. Chord = reading + hole Ø.
PCD
PCD = chord ÷ sin(180° × holes apart ÷ number of holes).
Holes apart
1 for neighbouring holes. On an even hole count, measuring straight across (number of holes ÷ 2) gives the PCD directly and has the smallest error.
Accuracy
A caliper error on the chord grows by 1 ÷ sin(180° × holes apart ÷ number of holes) on the PCD. On 8 holes measured across neighbours it is 2.6 times; straight across it is 1 times.
Nominal
Patterns are drawn to round sizes: whole or half millimetres, inch fractions (101.6 mm is 4 in), or a standard wheel PCD such as 5 × 114.3. Sizes inside the caliper band are marked.

Making a new part to fit the pattern?

The free Bolt Circle Layout gives the X and Y position and drilling code for every hole. The full CNC tools, from a simulator to setup sheets made from the G-code, sit behind a client login.

See the CNC tools